SpaBalancer Starter-Set II - for hot pots and sand filter systems

SpaBalancer StarterSet now with more content:

• 1 bottle SpaBalancer 1,0 l
• 1 bottle SpaBalancer UltraShock 1,0 l
• 1 pool tester including 30 tablets each for measuring UltraShock and the pH value
• 1 bottle SoftWater 0,5 l
• 1 can of pH-Minus granules 1,5 KG
• 1 digital pH Tester with 2 x calibration fluid

And all that in our special jute bag!

Have you bought a new whirlpool and would like to master the water care without problems, without chlorine as well as time-consuming measures? Then we have just the thing for you. With these products you are well prepared for everything. You will have water as fresh as a mountain stream. The weekly maintenance effort is only 5 minutes. You will no longer need to shower off after the whirlpool bath to get rid of the chlorine smell. You don't need to put on lotion after the bathing fun. Even people with neurodermatitis or simply sensitive skin can now enjoy their whirlpool bathing fun again without any worries.

Water care with SpaBalancer

Refilling

1. After refilling, first fill in SpaBalancer SoftWater. Depending on the hardness of the water between 150 ml and 250 ml / 1,000 liters.
2. Optional: In case of very hard water it is recommended to fill the SpaBalancer SoftWater filter additionally.
3. Then SpaBalancer and Ultrashock according to the table (day 1 Ultrashock, day 2 SpaBalancer), see under "Downloads" - "Water care instructions".

== >> Use biocides carefully. Always read label and product information before use!

Do not fill SpaBalancer and Ultrashock together. Always add Ultrashock on the first day and SpaBalancer one day later. When SpaBalancer is added, the water may become cloudy. This cloudiness usually disappears the next day. 

Filter cleaning

The filters should be cleaned twice a week for the first two weeks. Thereafter as needed. However, at least every two weeks. You will need a second filter to change.

1. Place the filter in a suitable container and insert the replacement filter into the pool.
2. Add 100 ml of SpaBalancer filter cleaner to 10 liters of water. The filter must be completely covered by the water
3. Leave the filter in the cleaning solution for one night
4. Now rinse the filter thoroughly. This is because any remaining filter cleaner can cause foaming in the spa.
5. Finally, allow the filter to dry and store it until the next filter change.